Omron Focus PM710-L, Инструкция по эксплуатации

Страница: 24 / 40

23
4. Maintenance
4.1 Cleaning
4.1.1 Drying the Pad
When the adhesive surface of the pad contains excess fluids such as sweat, dry it
by following these instructions. Using the pad without drying it may cause peeling
or shifting of the adhesive surface.
Turn the device over and dry the
adhesive surface of the pad.
Air-dry it until moisture is gone
(approximately 8 hours).
• Avoid direct sunlight.
• Drying the pad too long may cause adhesive strength to weaken. Store it
immediately after drying. Refer to sub-section 4.2.
4.1.2 Cleaning the Pad
When the pad becomes dirty or the adhesive strength is weak, clean it by
following these instructions. If the pad is used without cleaning, the treatment
intensity may feel weak.
1
Remove the device from the pad.
Lift the device while pressing the pad
release button.
Pad release
button
2
Clean the adhesive side.
Wipe the surface with a soft non-paper
based cloth moistened with water. Do not
damage the gel.
• Adding too much water to the adhesive
surface of the pad may reduce its
adhesion.
• Do not wash the pad with running water.