Omron Enterprise Manager 2100, Руководство пользователя

Страница: 31 / 96

Chapter 3: Installation
1. Identify the brackets by a letter stamped into the metal: F—Front and R—Rear.
2. Align the front bracket [2] with the front end of the outer track [1].
3. Attach the front L-bracket with two 4 mm M4 black screws and washers [3]. Torque
each screw to 2 ft-lb (3 N∙m).
4. Align the rear bracket with the rear end of the outer track [4].
5. Attach the rear L-bracket with two 4 mm M4 black screws and washers [5]. Tighten
each screw loosely, enabling the bracket to slide.
6. Repeat Step 1 through Step 5 for the second track.
Determine the Mounting Method for the Sliding Rail Kit
Determine which fastener holes you will use to attach the sliding rail kit to the rack posts. The
sliding rail kit adapts to different rack post profiles in several ways:
l
Adjust the position of the L-bracket to contact the inner or outer surfaces of the rack
post.
l
Rotate the L-clamp as necessary to clamp and fasten the L-bracket to the rack posts.
l
For some rack post profiles, you might be able to attach the L-bracket directly to the post
without requiring the L-clamp.
Attach the Track to the Rack Posts
The following procedure is typical of most rack post profiles.
Adjust the Track to Span the Rack Posts
Move the rear L-bracket so that both L-brackets span the outer faces of the front and rear rack
posts as follows:
1. Use masking tape to mark all four U-locations on the rack posts.
2. Position the track so that the front L-bracket is on the outer face of the front rack post.
3. Slide the loose rear L-bracket [1] until it aligns tightly with the outer face of the rear rack
post. Temporarily tape the rear L-bracket to the track to prevent it from moving.
4. Tighten the two 4mm M4 black screws and washers to secure the L-bracket to the track.
Torque each screw to 2 ft-lb (3 N∙m).
14413-200 Rev. A Enterprise Manager 2100 User’s Guide 31