4
Setup Guidance
The sensor input type, alarm type, control cycle, and other initial hardware settings that were made using DIP switches on previous models are
now made using the setup display on the E5ZN-SDL. Change the setup display by pressing the
LEVEL
and
MODE
Keys. The amount of time the
keys are pressed determines what parameter is entered.
Interpreting Typical Examples
Typical Example 1
M
M
M
This symbol means that
there are further
parameters. Keep pressing
the
MODE
Key until the
system switches to the
intended parameter.
Changing Parameters
Changing Values
Set values in each
display can be
changed by pressing
the
U
and
D
Keys.
Input type:
0 K thermocouple
−
200 to 1300
°
C
Control method: ON/OFF control
Alarm type:
2 upper limit
Alarm value 1: 20°C (Set the deviation in
Set point:
100
°
C
E5ZN unit number: 3
Channel number:
1
Power ON
Start operation.
Set the channel number.
Set the unit number.
Set the control method.
Set the alarm type.
Set input specifications.
Set alarm values.
Power ON
Process value/
set point
Input type
For
ON/OFF
control
Alarm 1 type
For PID
control
Control stops.
Operation Level
Initial Setting Level
Press the Key for at least three seconds.
Set the unit number and channel by
pressing the UNIT and CH Keys.
Press the Key for at least one second.
M
Process
value/set point
To operate
Alarm value 1
To stop
Operation Level
M
Operation Level
Initial Setting Level
Operation Level
M
M
M
M
Select "Run"
using the
U
and
D
Keys.
Press the
U
and
D
Keys to
set the alarm
value to 20
°
C.
Press the
U
and
D
Keys to set the
set point to 100
°
C.
Check the input
type.
Select ON/OFF
control by using
the
U
and
D
Keys.
Check the alarm
type.
Setup Procedure
