Omron E3NT-L, Руководство по эксплуатации

Страница: 26 / 66

27
User set parameters Section 4-3
4-2-3 Push buttons on the sensor
On the sensor, there are three push buttons for the setting of the sensor
(see
Figure 3 Operator controls and displays)
:
• Minus key
팫
• Plus key
팬
• Enter key
●
With these three push buttons, the operator moves through the sensor's menu
and sets the parameters in accordance with the application. Therefore, the
most frequently used parameters can be set directly on the sensor.
4-2-4 Set-up via a PC
All parameters of the sensor can be set with a PC and the OMRON Sensor-
SupportSoftware S
3
. The connection between the sensor and the PC is
established via an optical data interface. The data interface is connected to a
free COM port of a PC/laptop.
Refer to the separate operating instructions ABBO 0018 for further informa-
tion on setting with a PC and the SensorSupportSoftware S
3
.
4-3 User set parameters
The following parameters can be user set either by push buttons on the sen-
sor or with a PC and the set-up software (order separately) via the optical data
interface (order separately):
• Mode
• Output function
• Teach/set switching points
• Output switching
• Function on connector pins 2 and 5
• Switch-on and off delay
• Type of switch-off time function
• Type of display on the sensor
• Keyboard lock
• Energy saving mode
• Display direction
• Reset to factory defaults
The following functions can only be set with a PC and the set-up software
(order separately) via the optical data interface (order separately):
• Complete sensor locking