Omron DeviceNet 3G8F7-DRM21-E, Руководство по эксплуатации

Страница: 49 / 149

32
DeviceNet Connections
Section 2-5
(3) The wire colors are listed in the following table.
3. Tighten the line set screws for each line in the connector. Tighten the
screws to a torque between 0.25 and 0.3 N
⋅
m.
You will not be able to tighten these screws with a normal screwdriver,
which tapers at the end. You will need a screwdriver that does not taper at
the end, such as a large precision screwdriver.
When using a Thick Cable, allow sufficient cable to ensure that the tension
of the cable does not disconnect the connector.
Note The following diagram shows the dimensions of the OMRON
XW4Z-00C screwdriver, which is ideal for these DeviceNet connec-
tors.
4. Align the connector to the Board’s Connector and then insert the connector
until it is securely set in place. Firmly tighten the screws at both ends of the
connector. Tighten the connector mounting screws to a torque between
0.25 and 0.3 N
⋅
m.
Color Signal Symbol
Black Communications power supply (negative) V
−
Blue Signal LOW side CAN L
--- Shield S
White Signal HIGH side CAN H
Red Communications power supply (positive) V+
Use a flat-blade screwdriver
that does not taper at the end.
Side Front
0.6 mm 3.5 mm