Omron DeviceNet 3G8F7-DRM21-E, Руководство по эксплуатации

Страница: 48 / 149

31
DeviceNet Connections
Section 2-5
• PHOENIX CONTACT, AI-series Crimp Terminals
5. Cover the end of the cable with electrical tape or heat-shrink tubing as
shown in the following diagram.
2-5-2 Connecting Communications Cables
1,2,3... 1. Remove the connector from the Board’s DeviceNet Communications Con-
nector. (It isn’t necessary to remove the connector from the Board if it can
be wired in place.)
2. Orient the connector properly and then insert the lines in order from left to
right: black, blue, shield, white, and then red.
Note (1) Loosen the screws for securing the connector wires before inserting sig-
nal lines, power lines, or the shield wire. If the screws are not loosened
sufficiently, the wires cannot be inserted into the correct position. They
will enter the gap at the back where they cannot be secured in place.
(2) The connector and Board have colored stickers that match the wire col-
ors. The wire colors can be checked against the sticker color to check that
the cables are wired correctly.
Cable type XW4B-
05C10H1-D
XW4B-
05C10V1R0D
MSTB2.5/5-
ST-5.08AU
XW4B-
05C4-TF-D
XW4B-
05C4-T-D
XW4G-
05C1-H1-D
XW4G-
05C4-TF
Crimping
Tool
Using thin
cables Signal lines AI0.25-6BU AI0.25-8YE AI0.25-8YE CRIMPFOX
UD6
Power lines AI0.5-6WH AI0.5-10WH AI0.5-10WH
Using thick
cables Signal lines AI 2.5-8BU AI 2.5-8BU AI 2.5-12BU
Power lines AI 2.5-8BU AI 2.5-8BU AI 2.5-12BU
Electrical tape or
heat-shrink tubing
Black (-V)
Blue (CAN low)
Shield
White (CAN high)
Red (+V)