![background image](http://html.mh-extra.com/html/omron/c200hw-clk21/c200hw-clk21_operation-manual_742483321.webp)
296
Status Area and Troubleshooting
Section 9-2
Terminating Resistance Status: CIO 1500 + 25
×
(Unit No.) + 24
9-2-2
C200HX/HG/HE Controller Link Units
The status of the Unit and Network is indicated in the following manner in the
PLC.
Status Area
Duplicate Operating Levels/Refresh Error: AR 00
Routing Table Error/Unit Restart Bits: AR 01
Network parameter error
(CIO 1500 + 25
×
n, bit 0)
is 1: ON
The network parameter
data in the CS/CJ CPU
Bus Unit Area is corrupted.
Refer to
8-1-3 Network
Parameters
and reset the
data correctly. If the error
occurs again, replace the
CPU Unit.
Either set the EEPROM
Clear Bit in the DM Param-
eter Area to ON, or use the
Initialize network parame-
ters operation on the Main-
tenance Menu of the
Controller Link Support
Software to initialize the
network parameters and
then cycle the power sup-
ply.
There is an error in the net-
work parameter settings, or
node address of the local
node is larger then the
maximum address set
within the network parame-
ters.
Refer to
8-1-3 Network
Parameters
and reset the
network parameters or the
node address.
Bit status
Probable cause
Probable remedy
Terminating resistance status: 0: OFF
1: ON
A bit will be turned ON (1) the
next cycle when
1) The same operating level is
set more than once or
2) A refresh error occurs
between the Controller LInk
Unit and the PLC's CPU Unit.
Operating level 1
Operating level 0
Operating level 1
Operating level 0
1: Routing table error
Resets the Controller Link Unit.
Turn ON (1) and then OFF (0)
to reset Unit.
Operating level 1
Operating level 0
Содержание C200HW-CLK21
