Omron BU2002RWL, Инструкция по эксплуатации

Страница: 29 / 78

2
.Installation and connection
17
When using the included UPS monitoring software, the Windows standard UPS service, or the contact
signal, use the connection cable to connect the unit to the PC.
2-3-3. Connecting to a computer
See also
“7. Using the UPS monitoring software and Contact Signal” on page 38.
* If you do not use the UPS monitoring software and Contact Signal, this step is not required.
(2) Attach the terminal block cover (with cable clamp) to the unit.For BU2002RWL and BU3002RWL,
attach the cover after connecting the input cable.
BU2002RWL/BU3002RWL
Insert the upper part of the terminal block cover into the slit of the unit, and tighten it with two of
the included M3 screws.
Tighten the cable clamp dial to stabilize the wire.
φ
INPUT
OUTPUT
1
50-60Hz
G L2 L1 G L2 L1
170-278VAC
15A
φ 1 100/200/208/
220/230/240VAC
50-60Hz 15A
BU5002RWL
Insert the tab on the left side of the terminal block cover into the slit of the input terminal block cov-
er, and then run one of the included M3 screws through the hole on the right side of the terminal
block cover and tighten it.
Tighten the cable clamp dial to stabilize the wire.
INPUT
OUTPUT1 25A
G L2
L1 G
L2
L1