A
22E
G-319
A22E
Installing/Removing the Switch Blocks
Installing the Switch Blocks
Hook the small protrusion on the Mounting Latch into the groove on
the other side of the lever, then push up the Switch Block in the direc-
tion indicated by the arrow in the figure below.
Removing the Switch Blocks
Insert a screwdriver between the Mounting Latch and the Switch
Block, then push down the screwdriver in the direction indicated by
the arrow in the following figure.
Wiring
Wiring Round Crimp Terminals
Loosen the terminal screw from the Switch Unit until it completely
comes off the groove, insert a screwdriver as shown in the following
figure, then push up the washer in the direction indicated by the
arrow to temporarily secure it. Now, a round crimp terminal can be
connected. After inserting the terminal, tighten the screws to com-
plete wiring.
Lever
Switch Block
Protrusion
Mounting
Latch
Use either of the following screwdrivers.
Screwdriver
3 to 6 mm
3 to 6 mm
Flat-head
screwdriver
Phillips
screwdriver
Screw
Washer
Screwdriver
