30
•
EN
7
Operation
Mixer unit
1) Prior to switching on, turn down the master control
MAIN LEVEL
for the overall level to the left stop
position to avoid a possible switching-on noise.
2) First switch on the connected audio sources, then the PA system. The
PWR
indicator lights up green. If
the
LOW
indicator lights up red during battery operation, the battery should be recharged.
3) Adjust the
MAIN LEVEL
control to a level that the subsequent adjustments can be heard well via the PA
system.
4) Adjust the desired volume ratio of the signal sources with the level controls in channel 1-3. Turn the
controls of the inputs not used to zero.
5) Optimize the sound of the mixed signal with the tone controls.
6) A reverb effect created via the integrated effect processor can be added to the microphone signals of
channels 1 and 2. To do this, press down the
REVERB
button. In addition, you should always activate
the feedback suppression for the microphone signals with the
KILL FEEDBACK
button. This provides
crystal clear sound quality even at higher volumes, without annoying feedback whistling.
7) To improve the audibility of an announcement while a music program is running on channel 3, activate
the talkover function with the
CH 3 TALKOVER
button. Then the level of channel 3 is automatically
attenuated during a microphone announcement.
8) Determine the definite level for the overall volume of the PA system with the
MAIN LEVEL
control. In
case of overload the red
LIMIT
indicator lights up. If it lights continuously, turn back the
MAIN LEVEL
control accordingly.
9) After operation, switch off the PA system first. The
PWR
indicator goes out. The automatic charging for
the rechargeable battery is always active even if the unit is switched off. To prevent unnecessary power
consumption, always disconnect the mains plug from the mains socket if the unit is not used for a longer
period.
Setting up a Bluetooth connection with mobile devices
The PA system features a Bluetooth receiver allowing you to stream music wirelessly from your mobile
devices such as smartphones, tablets and notebooks.
1) First, press the
PLAYER/AUX
button to assign the audio player signal to channel 3.
2) Then press the
MODE
button (repeatedly) until the display shows "
BT NOT LINK
". The audio player
switches to pairing mode.
3) Activate the Bluetooth function at the Bluetooth source. The PA system is indicated by "
Bluetooth
" on
the display of the Bluetooth source. Pair the devices with each other. The display now shows "
BT
CONNECTED
". Play music at the Bluetooth source as you normally would and the sound will come out
of the PA system.
4) Use the level control in channel 3 to adjust the volume.
5) The Bluetooth source may also be operated via the audio player. To interrupt or continue the playback,
press the button [► ]. With the buttons [
] / [
] you can skip titles in forward or backward
direction.
