26
•
EN
23
MIX OUT output
XLR jack for routing the mixed signal (mono) to devices with line-level
inputs, e.g. another amplifier system.
24
Power input
Used to plug in the supplied power cord.
25
Fuse holder
Only replace the fuse when the device is disconnected from mains. Only
use fuses of the same rating and power.
26
Power on/off
Switches the PA system on/off.
26
DC 12V terminal
For alternative power supply from a 12 V source.
Hand-held microphone and pocket transmitter
No.
Element
Function
1
Microphone module
Dynamic microphone capsule with cardioid pick-up pattern.
2
Power switch
Switches the microphone on and off.
3
Battery compartment
To insert batteries, unscrew the cover on the microphone and
pull it down on the bodypack transmitter. Insert two 1.5 V
batteries as indicated.
Note: If the devices are not used for a longer period, please
remove the batteries to prevent damage in case of battery
leakage.
4
Operating switch
Upper position: on / center position: mute / lower position: off
5
Battery indicator
Lights up shortly after switching on and flashes red when the
batteries are exhausted.
6
Gain control
To correct the volume level of the bodypack transmitter.
Reduce the sensitivity if the volume of the transmitter signal is
too high and thus distorted. Increase the sensitivity if the
volume is too low and a poor S/N ratio results.
7
Headset microphone
Condenser microphone with cardioid pick-up pattern.
6
4
2
7
3
1
5
3
