Omnitronic WAMS-10BT Series, Руководство пользователя

Страница: 31 / 44

31
Receiver module
Antenna input
Audio player
Input selector switch
Selects the input signal for channel 1.
• Button pressed: signal of the jacks AUX or
CD/TAPE IN
• Button not pressed: signal of the audio player
Level control
To mix the signal of channel 1 to the master
signal.
Aux input
3.5 mm jack for connecting audio units with
line level (e.g. MP3 player) to channel 1.
When connecting the AUX input, the RCA
input is muted.
Line input
Stereo input (RCA L/R) jack for connecting
audio units with line level (e.g. CD player) for
channel 1.
Level control
To mix the signals of channel 2 and channel
3 to the master signal.
Microphone/line input
Combo inputs (XLR/6.3 mm jack) for
connecting a microphone or an audio unit
with mono line output (e.g. music instrument)
to channel 2 and channel 3.
Input selector switch
Switch channel 2 and 3 from microphone
input to line input.
Intensity control
Adjusts the intensity of the internal reverb
effect applied to channels 2 and 3 and the
wireless receiver.
Control indicator
Lights up blue as power indicator and red
when the signal level is too high; the limiter
will reduce the signal level to protect the
speakers.
Master control for the overall level
Tone controls
Controls for the high range (HIGH) and the
low range (LOW) for the mixed signal.
Battery capacity indicators
Show the charging state of the batteries. If
the red indicator LOW lights up, the batteries
should be charged.
Link output
6.3 mm jack to feed the mixed signal (mono)
to units with line level inputs, e.g. another
PA system.
Voltage selector switch
Charging indicator
• lights green: battery is being charged
• does not light: charging completed
Power on/off
Power input
Used to plug in the supplied power cord.
Fuse holder
Only replace the fuse when the device is
disconnected from mains. Only use fuses of
the same rating and power.
Receiver Module
Display of the transmission channel
Buttons for channel selection
Reception indicator
Audio signal indicator
Control MUTE LEVEL
Adjusts the threshold for interference
suppression.
Button ASC
To synchronize the receiver and the
transmitter. Thus, the microphone is set to
the transmission channel of the receiver.
Infrared interface
On/off switch and level control
By turning the control clockwise, the receiver
is switched on and the volume for the
microphone signal can be adjusted. By
locking the control into place at the left stop,
the receiver will be switched off.