Omnitronic RS-1222, Руководство пользователя

Страница: 19 / 31

10040100_V_1_1.DOC 19/31
Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
4. INSTALLATION
Install the device on a solid, plane, anti-slip, vibration-free, oscilation-free and fire-resistant surface.
Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be switched
off.
4.1 Inputs
A good cable run improves the sound quality remarkably. Input cables should be short and direct, since high
frequencies will mostly be absorbed if the cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables.
In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
GAIN
8
MIC
LINE
L/MONO R
STEREO AUX RETURN AUX SEND GROUP OUT TAPE IN TAPE OUT
L
R
MONO MONO MONO MONO
RECORDING MIXER
-10
+4
LOW CUT
75 Hz
G 1
G 2
PHONES
L
R
L
L L L L
1 1
R
R R R R
2 2
LINE 9-10
CTRL R OUT
MAIN OUT LINE 11-12 LINE 13-14
LINE 15-16
L R
MAIN OUT
At the mono input channels, the microphone signals are connected via the XLR-sockets, the line-signals via
the jack sockets.
Please note: you must only connect one kind of signal to a mono channel – either mic or line.
You can also run a stereo channel in mono when you only connect the left input socket.
MIC
Here, you can connect condenser microphones or dynamic microphones via balanced XLR-cables. For
condenser microphones, you can activate the phantom power via the +48V-switch. Please respect the
warnings under +48V-switch.