10006850_V_1_0
21/2
6
6. MIC BASS-CONTROL
Used to increase or lower the LOWs of the MIC input signal.
7. MIC MIDDLE-CONTROL
Used to increase or lower the MIDs of the MIC input signal.
8. MIC TREBLE-CONTROL
Used to increase or lower the HIs of the MIC input signal.
9. MIC LEVEL-CONTROL
With the MIC LEVEL-control, you can adjust the microphone volume.
10. PHONO / LINE / MIC-SWITCH
Used to select the input to be sent to the individual channel. Make sure that the PH/LINE or LINE/MIC-switch
on the rear panel is set properly.
11. GAIN-CONTROL
Used to set the level of the individual input signal. You can monitor the signal level via the Channel Display.
Reduce GAIN if the display´s red LEDs light up.
12. TREBLE-CONTROL
Used to increase or lower the HIs of the individual input signal.
13. MIDDLE-CONTROL
Used to increase or lower the MIDs of the individual input signal.
14. BASS-CONTROL
Used to increase or lower the LOWs of the individual input signal.
15. M1 / M2-SWITCH
Used to switch the MASTER Display from Master 1 to Master 2.
16. LINE INPUT-SOCKETS
Additional RCA and 3.5 mm mono-jack input sockets for CH-4/LINE 8.
Connect line sources like MP3-players via the 3.5 mm mono-jack socket. Make sure that the LINE/MIC-
switch is set to LINE.
17. REC OUT-SOCKETS
Additional RCA output sockets to connect your recording unit on the front panel. The ouptut level is not
affected by the master control.
18. DJ MIC TO REC-SWITCH
Press this button to route the DJ MIC to the REC socket in order to record the MIC signals as well.
19. MASTER LEVEL DISPLAY
The display shows the level of the left and right master output. Note that it does not display the record and
booth outputs.
20. MASTER 2-CONTROL
With the MASTER 2-control, you can adjust the MASTER 2 output level.
21. MONO/STEREO-SWITCH
Used to set the master output to mono or stereo. If you connected a mono-signal via one RCA-socket, you
can switch the output signal to STEREO in order to have a stereo output signal.
22. BALANCE-CONTROL
Used to adjust how much of the signal is sent to the left and right MASTER-socket.
23. BOOTH LEVEL-CONTROL
With the BOOTH LEVEL-control, you can adjust the level of the signal to the stereo booth monitor output.
This does not affect the level in the headphones.