Omnitronic EM-260, Руководство пользователя

Страница: 18 / 20

18
Switching on Phantom Power
In order to operate phantom-powered microphones, it is possible to switch on a 12 V phantom power
separately for each microphone input. To switch on phantom power, set the corresponding dip switch to
position ON.
Caution! Only switch on phantom power for microphones that require phantom power. If in doubt, please
contact your microphone manufacturer.
The phantom power must only be activated if all microphones are connected and the master control is
set to zero. During the stabilization phase (approx. 1 minute), you must not connect or disconnect any
microphones or adjust the output volume. Otherwise danger of speaker damage.
..............................................................................................................................................................................
6
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the PA system. Please use a soft lint-free and moistened cloth. Never
use alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers. If the power supply cable of this device becomes damaged, it has to be replaced
by a special power supply cable available at your dealer. Should you need any spare parts, please use
genuine parts. Should you have further questions, please contact your dealer.
Replacing the Fuse/Volage Selection
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Please note:
This fuse is being used for both 115 V and 230 V.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing. The fuse holder can be switched to one of two positions,
i.e. 230 V and 115 V.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!