33
works with the appropriate mixers. Insert the CD and select the desired track (Pause-mode). Start playback
from your mixer.
Please note that the Faderstart-function is a Cue-point Faderstart-function. This means that the CD-player
starts playback after activating the respective channel of the mixer and goes into Pause-mode and returns to
the Cue-point after activating the channel again.
Prerequisites for the Faderstart-operation:
The mixer has to be connected via a 3.5 mm mono jack with the CD-player. For starting the playback, the
jack's positive pin (tip) is to be connected with the audio mass via a short impulse. For pausing the playback,
the jack's negative pin (sleeve) is to be connected with the audio mass via a short impulse. The mixer has to
be equipped with a switch, button or fader that will connect the tip with the audio mass for starting the
playback and the sleeve for pausing the playback when the respective channel is activated.
6.13 End of operation
Before you switch off the device, please make sure that no CD remains in the player. All memorized Cue-
points, samples and effect-parameters are stored inside the CD-player and can be also be recalled after
switching the CD-player off.
7. PRECAUTIONS
This CD player cannot be compared to conventional Hifi CD players. This player is much more rugged in
order to withstand the strenous road use and consistent transports of mobile discotheques.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
Is your amplifier and your mixer properly adjusted?
Have you kept to all instructions given in this manual?
SYMPTOMS
POSSIBLE CAUSES
SOLUTION
Device does not react when swit-
ching on.
Connection to mains disrupted.
Check
AC
plug
and
AC
connection.
Player does not start operation
CD is badly positioned or dirty
Reposition CD with label atop or
clean with a dry and soft cloth.
No
sound
Check the mixer and amplifier
connections
Possibly exchange connections.
Does not read the program
The player is in normal playback
mode
Press the Play/Pause-button and
re-program
Pop
noise
Mixer or amplifier connections
inapropriate
Check cable and jack quality
Faderstart does not work
Missing Audio Out-connection
Connect the Audio Out-sockets
with the Line-input sockets of your
mixer
8. CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
