Omnitronic ACS-510, Руководство пользователя

Страница: 20 / 24

20
6
MAKING THE CONNECTIONS
Switch off the PA system and the units to be connected before making or changing the connections.
Audio Sources
As signal source, microphones and audio units with line level (e.g. smartphone, MP3 player, mixer) can be
connected.
1
Connect microphones to the input jacks of channels CH 1 [10] and CH 2 [11]. Set the corresponding
MIC/LINE selector switch [3] to position MIC.
2
There are several input jacks available for audio units with line level:
• Use input CH 1 [101] for units with mono output (e.g. instrument preamplifiers) and input CH 2 [11] for
units with stereo output (e.g. mixer). Set the corresponding MIC/LINE selector switch [3] to position
LINE.
• Inputs CH 3 [12] and AUX [4] are also designed for stereo signals. The RCA jacks [12] will be switched
off when the 3.5 mm jack [4] is connected.
Satellite Speakers, Recording Unit and Second PA System
1
Connect the satellite speakers to the SPEAKER OUT jacks as described in chapter 5. Set the SETUP
selector switch [91] accordingly.
2
The OUT jacks [13] can either be used to route the input signal of channel CH 2 or the master signal to
a recording unit or a further active speaker system. The MODE selector switch [8] determines which
output signal is present.
3
For larger PA applications, two ACS-510 systems can be combined. Connect the LINK IN/OUT jacks
[14] of both units with a stereo jack cable. The first unit serves as the signal source for the second unit.
Thus, use the mixer channels of the first unit as usual and set all gain controls [7] to minimum at the
second unit.
Connection to the Mains
Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an outlet
(AC 230 V, 50 Hz). The device can also be operated with AC 115 V, 60 Hz ~. For this purpose, set the
voltage selector switch to the 115 V position.
Connector Configuration