80-J7616-1 Rev. C
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
18
Typical TT150 Installation Sequence
Trailers and flatbeds often differ from manufacturer to manufacturer. The TT150 system was
designed to work with a variety of trailer types; however, every installation is unique and should
be thoroughly planned out before implementation.
1.
Identify the installation location.
2.
Mount the unit.
3.
Route the power cable and cut as needed to the appropriate length
4.
Connect wires to the 7-way.
5.
Use the TT150 Field Service Tool (FST) to configure the TT150 and to perform system
verification. The FST is also used to diagnose any problems with the system.
Tools and Supplies Needed for Installation
The following tools and supplies are recommended for performing installations.
•
Mobile device with internet access to the TT150 Field Service Tool
•
Pop-rivet gun (suitable for use with 3/16" rivets)
•
Crimper
•
Wire stripper
•
Felt-tip pen (or grease pencil, or scratch awl)
•
3/8" nut driver or socket and ratchet
•
Assorted 7-way receptacle tools
•
Drill
•
7/8" drill bit
•
3/16" drill bit
•
Rubbing alcohol and a towel
