Omnifilter BF35, Руководство по установке

Страница: 3 / 16

ENGLISH
• 3 •
2.
Screw white fittings into housing cap by hand. Use a wrench to tighten
firmly. DO NOT OVER-TIGHTEN. About one thread should remain visible.
NOTE: If using mounting bracket, be sure to insert fittings through bracket
before threading into filter cap.
3.
Measure length across assembled fittings and subtract 3 inches. Mark
section of pipe to be removed.
NOTE:
Approximately 8-1/2 inches will be removed. Using a pipe cutter or
hacksaw, cut pipe and remove marked section. File or sand sharp edges
on remaining pipe.
4.
Mark the ends of the cut pipe 1 -1/2 inches from the end.
5.
Align filter assembly with ends of pipe, making certain the “FLOW” arrow
is pointed in the direction of your water flow. It will be necessary to spread
ends of pipe apart to install filter assembly. Insert one end of pipe into the
quick-connect fitting. Firmly push the pipe in up to the 1-1/2 inch mark on
the pipe. Insert second end of pipe into opposite side up to mark on pipe
(A)
Turn on water supply.
(B)
Slowly turn handle counterclockwise
1/2 turn on housing to allow filter to fill with water, (C) then depress red
pressure-relief button on top of cap to release trapped air.
(D)
Open nearest faucet and flush cartridge for 5 minutes.
6.
Close faucet and check for leaks.
CAUTION
If water pipes are used to ground electrical systems,
appliances or phones, be certain to install a jumper wire. Contact a
qualified electrician with any questions about your home’s
electrical system.
3
A
C
B
D
5
2
1.5"
1.5"
4