
2
| OMNIA VOCO® 8 - QUICK START SETUP GUIDE
Mic/Line Inputs and Outputs
Each of the 8 analog inputs can accept either a microphone level signal (with selectable Phantom
power and pad) or a line level signal. Input connections are provided through a set of Neutrik
“combo” connectors (pin 2 hot; tip hot). Analog inputs and outputs are also provided on a pair of
female DB25 connectors conforming to the Tascam standard pinout.
Tascam standard DB25 pinout used for analog I/O
(Female connector on chassis, male connector on cable)
Input Status Indicator LEDs
Next to each of the combo connectors is an LED that indicates the status of Phantom power and
the switchable -20 dB pad. These settings are controlled through the Remote Gateway software (see
Chapter 13).
CAUTION:
Ensure Phantom power is only enabled on channels where it is necessary. Damage may
result to microphones or sources not designed to accept Phantom power.
n
Off: Phantom power off, pad disabled
n
Red: Phantom power on, pad disabled
n
Green: Phantom power off, pad enabled
n
Orange: Phantom power on, pad enabled
These LEDs will all briefly illuminate orange at power up but should reflect the current status once
the unit is fully operational.
Note:
Later software/hardware revisions changed the designation of the “Green” LED condition
to indicate whether or not a channel is licensed for audio processing. As of software ver-
sion 1.15, all channels should be available for basic preamp and I/O functions, regardless
of whether or not processing functions are licensed.
Содержание voco 8
Страница 17: ...THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 18: ...THIS PAGE INTENTIONALLY LEFT BLANK...
Страница 19: ...THIS PAGE INTENTIONALLY LEFT BLANK...