Omni Cresco, Руководство пользователя

Страница: 26 / 40

19 USING A “PLAY BACK” CYCLE
To recall and perform a memorised “ PLAY BACK” cycle, act in the following way.
Press LOAD, verify that the machine is not carrying out a cycle.
When pressing the key, if the machine emits an acoustic warning
(double beep), then the command has not been carried out, due
to the presence of a situation, in which the LOAD is deactivated.
Press JOG + and JOG - to select the programme number (L.rEc1
– L.rEc9) to be run.
Press LOAD or AUT-MAN-OK to load the selected cycle.
An acoustic signal confirms the saving and the display will show
(in an alternating mode) the total number of processed pallets
and the Play Back cycle, which has just been loaded with the
wording “PLY-“ and the relating position number.
In case of loading of a programme, in which no Play Back cycle
has been saved, an acoustic warning (double beep) is emitted.
Press START to start the cycle.
The wording “StP” is displayed as well as the number of steps,
matching with the commands, ordered to the user.
The Play Back cycle is run with the same value of the
parameters, with which it was carried out.
When the Play Back cycle is running, it is possible to modify the
value of the Manual stretch (G4) pressing the appropriate button.
When the Play Back cycle is running, it is possible to modify the
value of the Manual stretch (G4) pressing the appropriate button.
If LOAD and START buttons are pressed accidentally, press RESET to cancel the operation
CRESCO UCP REV10
28