Omni Cresco, Руководство пользователя

Страница: 23 / 40

15 USE OF A CUSTOMIZED CYCLE
- Press the LOAD key with the machine in the AUTOMATIC mode and check that the machine is
not carrying out a cycle.
When pressing the key, if the machine emits an acoustic warning (double beep), then the
command has not been carried out, due to the presence of a situation, in which the LOAD is
deactivated.
- Press JOG + and JOG - to select the programme number (L-Pr1 – L-Pr9) to be run.
The led of the cycle programe flashes thus showing which standard cycle has been saved in
the selected customized cycle.
By pressing a cycle button, the display shows the letter “L”, as well as the value next to it, with
which the parameter in that selected cycle has been saved.
- Press LOAD or AUT-MAN-OK to load the selected cycle.
An acoustic warning confirms the loading and the display shows the total number of pallets
processed by the machine.
- Press START to start the cycle.
16 MANUAL MODE
The Manual mode is used to manually control the machine.
If the carriage is going down and finds an obstacle, the machine enters into the safety (“Sic”) mode
and passes directly in the Manual mode in order for the operator to exit from this dangerous
situation.
In the Manual mode, the following buttons are used:
-
Table rotation: until the button is pressed, the table rotates; in case of prolonged pressing of
the button, an acoustic warning is emitted and releasing the button, the table continues to turn.
Press the button again to stop table rotation.
- Carriage ascent: until the button is pressed, the carriage goes up.
- Carriage descent: until the button is pressed, the carriage goes down.
- Film tension adjustment: by a simple pressure of the button, it is possible to modify film tension.
Each time one of these buttons is pressed, the value of the relating set parameter is displayed
(flashing) and it can be modified instantly by means of the + and - buttons.
17 “PLAY BACK” CYCLE
The machine can carry out nine different non-standard wrapping cycles, which are totally user-
configured. The cycles are characterised by a sequence of operations and by their duration. These
operations and their duration are decided by the user through a saving procedure in the
“PLAY
BACK” cycle.
CRESCO UCP REV10
25