Omni Cresco, Руководство пользователя

Страница: 16 / 40

6 TURNING ON
If the control panel is off, press the ON/OFF switch to power it up, then wait a few moments.
The number of the software version The number of the software version of the type of wrapping
machine (which can be modified by G21), and then, the value of the number of pallets completed
(from the last reset of the memory) will be displayed for a few seconds.
The RESET led flashes.
Press RESET to start the machine. Wait for the end of the reset cycle and the end of the acoustic
signal to begin using the machine.
When the RESET button is pressed, an acoustic signal is emitted. The rotating table and the
carriage reach their zero positions.
Once the RESET cycle has finished, the machine will have the same settings it had before it was
last shut down. The machine has been programmed to carry out different wrapping cycles. The
operator shall select the cycle which corresponds best to the characteristics of the load to be
wrapped. Select the cycle type to be carried out and set the parameter values according to the
specific needs.
CRESCO UCP REV10
18