Page 24
Indoor Unit
Installation
7. Connect the electric auxiliary heating control
wire of the wire controller to the electric auxiliary
heating terminal of the 24V module board (any
of the AUX terminal block can be used). The
terminal of the module board is shown in the
figure below.
NOTE:
The electric heating control wire of the wire
controller can be connected to any of
the AUX two terminal blocks.
9. See the figure below for the position of the
power supply ground wire. Screw the power
input wires of each group to ensure reliable
grounding.
10. Remove the rubber cap and insulation from
the electric auxiliary heat module accessory
bag, and attach the insulation to the
rubber cap.
8. Please choose wire sizing based off of electrical
requirements of the system. Base all wire and
breaker sizing off of local and national codes.
