omisa 6160/LI, Инструкция по эксплуатации и обслуживанию

Страница: 5 / 22

O.M.I.S.A. Srl – 6160/LI - Use and Maintenance Instruction Manual - Version 1/2016
5/22
Before feeding the electric planing tool, make sure that the used electrical panel comply with the
technical features of the electric planing tool and above all that is equipped of grounded wire.
Pair of main clamps for pipes fastening and relevant reductions:
The pair of main clamps, made in steel, allows a safety locking of pipes and/or fittings to be welded.
They have been made in order to house different reductions to clamp pipes and fittings from Ø40 to
Ø160mm. The upper reductions are shaped to make also branches and tees at 45° and 60°.
Clamps are 7,5° rotable and it IS enough, without removing the screws (A), to unscrew the clamp
group up to the end of the buttonhole positioned on the clamp support (B).
Do the same operation on the other jaw turning it on the opposite side. I will get a 15° segment.
Picture 2 Picture 3
Work bench frame/ protection for transport; tool box for thermoelement and reductions:
The work bench frame /transport protection is made of steel to assure stability to the whole machine
during welding process and when the job is finished, it is able to grant a good protection during
transport.
On the frame is possible to position the tool box for thermoelement, reductions and equipped pipe
supports (from Ø40 to Ø160; Ø56 and Ø140 optional)
All parts of the machine 6160/LIare made in order to withstand to atmospheric agentattack.