Safety instructions
9
2
Safety instructions
Before operating DANEO 400, carefully read the following safety instructions. Only operate (or even
turn on) DANEO 400 after you have read this User Manual including the
“
Technical data
”
chapter and
fully understood the instructions herein.
2.1
For your safety
DANEO 400 may only be operated by trained personnel. Any maloperation can result in damage to
property or persons. The binary/analog I/O terminals of DANEO 400 can conduct life-hazardous
voltages.
2.2
Rules for use
•
DANEO 400 must be used only when in a technically sound condition. Its use must be in
accordance with the safety regulations for the specific job site and application. Always be aware
of the dangers of high voltages. Pay attention to the information provided in DANEO 400
documentation.
•
The instructions provided in this User Manual and associated DANEO 400 documentation are
considered part of the rules governing proper usage.
2.2.1 Orderly practices and procedures
•
Keep the DANEO 400 Quick Start Guide, which contains printed safety instructions, available
on site where DANEO 400 is used.
•
Personnel assigned to using DANEO 400 must have read the DANEO 400 Quick Start Guide
and fully understood the instructions therein.
•
Do not carry out any modifications, extensions, or adaptations at DANEO 400.
2.2.2 Operator qualifications
•
Installation and configuration of DANEO 400 should only be carried out by authorized and
qualified personnel.
•
Personnel receiving training, instruction, direction, or education on DANEO 400 should remain
under the constant supervision of an experienced operator while working with the equipment.
2.2.3 Safe operation procedures
•
Before wiring the terminals, verify that the conducting parts are de-energized. The terminal
connectors have hazardous live parts.
•
Do not operate DANEO 400 under wet or moist conditions (condensation).
•
Do not operate DANEO 400 when explosive gas or vapors are present.
•
When setting up DANEO 400, make sure that the ventilation holes on the rear of the device
remain unobstructed.
•
Do not open DANEO 400. There are no user serviceable parts inside. If DANEO 400 is opened
by unauthorized personnel, all guarantees are invalidated.
•
DANEO 400 is designed to measure signals that are Measurement Category I, II, III, and IV, as
described in the IEC 60664. The 10 measurement inputs are only functional isolated from each
other (4 mm creepage distance). Never mix signals from different measurement categories!
Содержание DANEO 400
