![background image](http://html2.mh-extra.com/html/omega/vrt400-series/vrt400-series_instruction-manual_4052208012.webp)
18
19
SPINNING BRUSH DISASSEMBLY AND WASH
SPINNING BRUSH ASSEMBLY
Spinning brush
Silicone brush
Cleaning brush
Remove the spinning brush
from strainer.
Detach the silicone brush from
spinning brush.
As shown to the left, hold the outer part of
silicone brush with your fingers an pull it out
to the arrow direction. It is recommended
to remove it according to the above method.
If pulling it by force, silicone brush may be
torn or spinning brush may be damaged.
With cleaning brush, wash inside and
outside of spinning brush like brushing
under the running water.
Wash silicone brush in the same way under
the running water.
Brush
groove
Outer wing
Down
(shorter part)
UP
(longer part)
Inner
wing
Check the groove of the spinning brush
and the direction of silicone brush.
There are grooves to insert silicone brush in
the spinning brush.
Silicone brush has inner wing
and outer wing.
As shown to the left, let ‘inner wing’ face
the spinning brush.
Insert the silicone brush into
the spinning brush.
According to the N o.1 above, let the longer
part of inner wing face upward.
Hold the outer wing of silicone brush
with your thumb and index finger and
insert the inner wing into the groove
of spinning brush.
Pull the inner wing tight enough.
Push silicone brush from the outer side
of spinning brush and pull ‘inner wing’ in
the direction of inside of the spinning brush
with the other hand as shown to the left.
Hold the outer wing of silicone brush
Pull it until you cannot pull it any longer.
If units are operating without fully assembled,
there is a risk of breakage.
Hold up and down of ‘outer wing’ and pull
it tight enough.
SPINNING BRUSH
SILICONE BRUSH