5
2.1 Parts of the Receiver (continued)
17
Diagnostics LED: (Yellow and Green) Diagnostics: at boot-up they light up for
2 seconds, then turn off;
DHCP: if DHCP is enabled, they blink and stay solid periodically
Network Link LED: (Green) Solid: Indicates good network link.
Activity LED: (Red) Blinking: Indicates network activities (receiving or sending packets).
18
Receive LED (blue): Indicates the Receiver is ready to receive data from the
Connector/Transmitter(s).
19
Antenna connector
2.2 Mounting - Receiver
Position unit where required. Mark and drill the two screw holes. Once the bracket is
mounted to the wall: align back of unit over the three bracket clips, when engaged, slide
downward, the unit will snap in place.
Version A: Metal Enclosure Version B: New Plastic Enclosure
Figure 2.2 Mounting the Receiver
Attach antenna (refer to
Section 5
for Environmental/Operating Conditions) and attach
power supply.
If unit is to be mounted on a flat surface, you may take the bottom rubber feet off
the unit.
66.0 [2.60]
REF
33.0 [1.30]
93.1
[3.67]
REF
38.1
[1.50]
27.3
[1.07]
Bracket Clips (3)
Drill 2 HOLES
3.6 [ 0.14]
Use #6 Screws (Provided)
to Mount the Bracket
Ethernet
Ethernet
90.3
[3.56]
REF
32.4
[1.27]
11.7 [0.46]
38.1
[1.50]
61.6 [2.42] REF
Bracket Clips (3)
Bracket Snap
Drill 2 HOLES
3.17 [ 0.125]
Use #4 Screws (Provided)
to Mount the Bracket
