8
position. Do not turn the key to the "Start" position.
Deactivation
- After 15 or 30 minutes
(programmable)
the RS unit
will turn the engine off.
- To stop the engine by remote control, simply press the lower left button again.
- Stepping on the brake pedal will turn the engine off.
- Opening the hood will turn the engine off. If the hood is open when an activation
attempt is made, the RS unit will not respond, and will not start the engine.
- Turning “on” the Valet Switch will also stop the engine.
Valet Mode
The RS unit may be placed into a “valet mode” which prevents the remote
start feature from being activated. Valet Mode should always be used when you
do not wish for remote start to be operated, such as when you leave your vehicle
with a valet parking attendant, mechanic or if you loan it to another person. An
“on/off toggle” switch, the Valet Switch, is used for this, and it is typically mounted
within easy reach of the driver. To engage the Valet Mode:
- At any time simply flip the Valet Switch to the “on” position. Three seconds later
the parking lights will flash 3 times to indicate Valet Mode.
Once the RS unit is in Valet Mode, an attempt to remote start will instead be
acknowledged by 4 parking light flashes, but no starting attempt.
- To turn off Valet Mode, with the ignition switch “On” simply flip the Valet Switch
33
22 Gauge
Red Wire:
+12 Volt Output For Optional Relay Coil
Connection If Needed.
The Red wire supplies constant 12 Volts that can
be used to power the relay's coil only- DO NOT use this Red wire for the optional
relay(s) pin.
W I R I N G - 3 Wire Connector
22 Gauge
Blue Wire:
500mA Negative Ignition Output
Connection If Needed.
This 22 gauge Blue wire is a 500mA Negative
output having basically the same operation as the 12 gauge Blue Ignition output.
If two or more Primary Ignition wires are present in the vehicle an optional relay is
needed, connected to this wire
as shown in the diagram on the next page
.
This harness, which plugs into the Red 3-pin port on the control module, can
be used, if needed, to configure optional relays to energize additional Ignition or
Starter circuits. Also, Omega OEM security bypass interfaces use the Blue port.
22 Gauge
Green Wire:
500mA Negative Starter Output
Connection If Needed.
This 22 gauge Green wire is a 500mA Negative
output, which has the same operation as the 12 gauge Green Starter output. If a
second Starter wire is present in the vehicle, an optional relay will be needed,
connected to the 22 gauge Green wire
as shown in the diagram on the next page
.
