21
22-Gauge
Green Wire:
(+) Glow Plug
Input
Connection If Needed.
The Green wire allows the RS-3A to be used with
diesel engines. Connect the Green wire to the wire in the vehicle which pow-
ers the glow plugs, or the wire which illuminates the “Wait To Start” light on the
instrument panel. When connected, the RS unit will not engage the starter if the
Green wire has +12 Volts; in other words, using this wire simply delays the RS
unit’s engagement of the starter. If the “Wait To Start” light in the vehicle has
a Negative switching circuit, it can still be used by simply reversing the polarity
with an optional relay.
22-Gauge
Light Blue Wire:
(+) Ignition Control Out-
put
Connection If Needed.
Since the RS-3A is activated by a host unit, the
host unit should also deactivation, or turning off the engine once it is started.
The host unit, however, may not operate when the vehicle’s ignition is “On”. The
Light Blue wire has +12 Volt output when the ignition key is “On”, but when the
ignition is on during remote start operation.
If the host unit stops operating during remote start operation cut its existing
+12 Volt ignition supply wire and connect the Light Blue wire to the host unit side
of the cut (insulate the unused original supply wire). This will allow the host unit
