Omega ODWF4510X, Руководство пользователя

Страница: 8 / 32

08 ODWF4510X User Manual
Prior to Installing Appliance
WARNING: ELECTRICAL SHOCK HAZARD
Disconnect electrical power before installing dishwasher.
Failure to do so could result in death
or electrical shock.
IMPORTANT:
The installation of the pipes and electrical
equipments should be done by professionals.
Power Connection
WARNING: FOR YOUR PERSONAL SAFETY
•
Do not use an extension cord or an adapter plug
with this appliance.
• Do not, under any circumstances, cut or remove
the earthing connection from the power cord.
Electrical requirements
Please look at the rating label to know the rating voltage and
connect the dishwasher to the appropriate power supply.
Use the required fuse 10A/13A/16A, time delay fuse or circuit
breaker recommended and provide separate circuit serving
only this appliance.
Electrical connection
Ensure the voltage and frequency of the power being
corresponds to those on the rating plate. Only insert the
plug into an electrical socket which is earthed properly.
If the electrical socket to which the appliance must be
connected is not appropriate for the plug, replace the socket,
rather than using a adapters or the like as they could cause
overheating and burns.
WARNING: Ensure that proper earthing exists before use.
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded 3/4 inch
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear. This precaution is needed to avoid the risk
of the water inlet to be blocked and damage the appliance.
Safety Supply Hose
The safety supply hose consists of double walls. The hose's
system guarantees its intervention by blocking the flow
of water in case of the supply hose breaking and when
the air space between the supply hose itself and the outer
corrugated hose is full of water.
WARNING:
A hose that attaches to a sink spray can burst if it is installed
on the same water line as the dishwasher. If your sink has
one, it is recommended that the hose be disconnected and
the hole plugged.
Connecting the Safety Supply Hose
1. Pull the safety supply hose completely out from storage
compartment located at rear of dishwasher.
2. Tighter the screws of the safety supply hose to the faucet
with thread 3/4 inch.
3. Turn water fully on before starting the dishwasher.
Disconnecting the Safety Supply Hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Installation Instructions
INSTALLATION INSTRUCTION
Ensure the voltage and frequency of the power being corresponds to those on the
rating plate. Only insert the plug into an electrical socket which is earthed
properly. If the electrical socket to which the appliance must be connected is not
appropriate for the plug, replace the socket, rather than using a adaptors or the like as
they could cause overheating and burns.
Electrical requirements
Electrical connection
Ensure that proper earthing exists before use
About Power Connection
WARNING
For personal safety:
Do not use an extension cord or an adapter
plug with this appliance.
Do not, under any circumstances, cut or remove
the earthing connection from the power cord.
The installation of the pipes and electrical equipments should be done by professionals.
Attention
WARNING
Electrical Shock Hazard
Disconnect electrical power before
installing dishwasher.
Failure to do so could result in death or
electrical shock.
13
Please look at the rating label to know the rating voltage and connect the dishwasher
to the appropriate power supply. Use the required fuse 10A/13A/16A, time delay fuse
or circuit breaker recommended and provide separate circuit serving only this appliance.
Safety Supply Hose Regular Supply Hose