Omega ODWF4510X, Руководство пользователя

Страница: 24 / 32

24 ODWF4510X User Manual
Problem Possible Cause Solution
Dishwasher doesn't start Fuse blown, or the circuit break tripped Replace fuse or reset circuit breaker.
Remove any other appliances sharing
the same circuit with the dishwasher.
Power supply is not turned on Make sure the dishwasher is turned on
and the door is closed securely.
Make sure the power cord is properly
plugged into the wall socket.
Water pressure is low Check that the water supply is
connected properly and the water
is turned on
Door of dishwasher not
properly closed Make sure to close the door properly
and latch it.
Water not pumped from dishwasher Twisted or trapped drain hose Check the drain hose.
Filter clogged Check coarse the filter.
Kitchen sink clogged Check the kitchen sink to make sure
it is draining well. If the problem is
the kitchen sink that is not draining,
you may reuquire a plumber than an
appliance repairer.
Suds in the tub Wrong detergent Use only the special dishwasher
detergent to avoid suds. If this occurs,
open the dishwasher and let suds
evaporate. Add 3.78L (1 gallon) of cold
water to the bottom of the dishwasher.
Close the dishwasher door, then select
any cycle. Initially, the dishwasher will
drain out the water. Open the door
after draining stage is complete and
check if the suds have disappeared.
Repeat if necessary.
Spilled rinse-aid Always wipe up rinse-aid
spills immediately.
Stained tub interior Detergent with colourant may have
been used Make sure that the detergent
has no colourant.
White film on inside surface Hard water minerals To clean the interior, use a damp
sponge with dishwasher detergent
and wear rubber gloves. Never use
any other cleaner than dishwasher
detergent otherwise, it may cause
foaming or suds.
There are rust stains on cutlery The affected items are not
corrosion resistant. The items should be
corrosion resistant.
Troubleshooting
(Continued)