Omega OCC64TZW, Инструкция по эксплуатации

Страница: 12 / 17

9
OPERATING INSTRUCTIONS
Touch Control Safety Functions
The following safety functions are available to avoid unintended operations.
Sensor Safety Cut-Off
Button monitoring is included to prevent the appliance from unwanted button operation. In cases where one
or more buttons are pressed for longer than 12 seconds, the buzzer will sound for ten minutes to indicate
an incorrect operation. For example, an object may be placed on a button, or there could be a sensor
failure and so on.
The safety switch-off will cause the hob to go into S-mode and all heater displays will flash “ F ”. If there is
no incorrect operation present, both the visual and audible signals will disappear.
If residual heat is present, “ H ” will be displayed on all other heater displays.
Over Temperature Switch-Off
Due to the controls being very close to the heater in the middle of the front of the hob, it can occur that an
incorrectly placed pot is not sensed by the sensor safety cut-off therefore heating up the hob to a very high
temperature. This makes the glass and the buttons dangerous to touch.
To prevent the hob control unit from damage, the controls constantly monitor the temperature and switch
off if overheating occurs.
This will be indicated by the letter “ t ” in the heater display until the temperature decreases.
Once the temperature has dropped, the “ t ” in the heater display will disappear and the hob control unit will
revert back into S-Mode. This means that the user can reactivate the appliance by pressing Power On/Off
touch control.