![background image](http://html1.mh-extra.com/html/omega/executive-classicone/executive-classicone_owners-manual_3971054002.webp)
Remote Transmitter Operations
Pressing the PANIC button
for 3.5 seconds will activate the system, flashing
the lights and sounding the horn; a further
press of this button will deactivate the system,
into the disarmed state. If desired, this button
can be programmed to operate the additional
optional output instead of the panic feature.
Pressing and releasing the LOCK
button arms the security
system and locks the
doors. Pressing and
holding this button for
3.5 seconds will, in
addition to the arming
and locking, also
activate the "panic"
operation.
Pressing and releasing the UNLOCK
button disarms the system and unlocks
the doors unless the
system is activated. The
unlock operation may be
configured so that pressing
the unlock button once
disarms the system and
unlocks only the driver's
door, and pressing a
second time will unlock all
of the doors.
PANIC
OPTION
Pressing and releasing the
OPTION button twice arms
or disarms the system without
the confirmation horn chirps.
Pressing this button for 2.5
seconds can be used to activate
an optional function such as trunk
release.
Page - 5
UN
LOCK
LOCK
Page - 6
Arming and Disarming the System
"Arming" the Executive Model One locks the doors and places the security system
into a state in which the vehicle is monitored for intrusion attempts. There are two
different methods of arming the system: "active" arming by use of the remote
transmitter, and automatic, or "passive" arming, which is programmable.
Active Arming: The Model One can always be armed with the remote transmitter,
provided the ignition switch is "off" and the system is not in Valet Mode.
Simply press the transmitter LOCK button once. The doors will lock, the parking lights
will flash once, the vehicle's horn will chirp once, the LED Status Light will begin
flashing, and the starter interrupt circuit engages to prevent any attempt to start the
vehicle. When arming the UltraOne system, the dome light also flashes once. Three
seconds after the horn chirp the system becomes fully armed. Once armed, the
system will activate if an intrusion attempt is detected. If desired, the system may be
armed without the normal confirmation horn chirp by pressing and releasing the
transmitter's OPTION button twice within 3 seconds.
Upon active arming, if any protected circuit except for the doors is inoperable, the
horn will chirp three times and the parking lights will flash three times. This is Arming
Bypass, and when it occurs, protection for the affected circuit will be temporarily
bypassed. For example, if the trunk is left open, you can still actively arm the system
from the transmitter, but with the indication that a protected circuit is not secure.
After arming, the bypassed circuit will automatically be reinstated for protection
should it become operative, i.e., if the trunk is closed, 3 seconds later protection of
this circuit is restored. When a circuit is in a bypassed state, all other operating
circuits will be protected normally. If desired, this feature may be custom programmed
to also operate if a door is open upon when arming the system with the transmitter.
Passive Arming: The Model One can be custom programmed to arm itself
automatically when the vehicle's last door is closed; this is the Last Door Arming
feature. If this feature is programmed to operate, the moment the last open door is
closed the horn chirps once and the parking and interior lights flash once to confirm
that all points of entry are closed, and that the arming sequence has begun. The
arming period lasts 30 seconds, and is indicated by a fast-flashing LED status light.
Thirty seconds after the last door was closed, the horn will chirp again, the parking and
interior lights will flash once, confirming completion of the Last Door Arming sequence.
When this occurs the LED status light changes to flashing slowly, and the system is
fully armed three seconds later. If a point of entry is reopened before the single chirp
and light flash occurs at 30 seconds, the Last Door Arming sequence stops, but will
start over again when the opened point of entry is closed again. To temporarily prevent
the system from Last Door Arming (example: while vehicle is being refueled), you
should put the system into Valet Mode or leave the vehicle's door open (in most cases,
turning on the dome light will suffice). The "Last Door Arming" feature offers a high level
of security, since you do not have to remember to arm the system each time you exit
Page - 7
from your vehicle, and may qualify you for an insurance discount. One important
aspect of the Last Door Arming's operation is to remember that the ignition switch has
to be on, then turned off, then the vehicle door closed to initiate the Last Door Arming.
Opening and closing a door without first turning off the ignition switch will not initiate
the Last Door Arming.
A separate programmable feature may be utilized to have the doors automatically
lock when the 30 second horn chirp and light flash occurs. The previously mentioned
Arming Bypass feature cannot operate with Last Door Arming; it only works when
actively arming the system from the transmitter because all protected entries must
be closed to initiate Last Door Arming. Of course, you can still arm the system
instantly from the remote transmitter at any time during the 30 second Last Door
Arming sequence.
Disarming: Press and release the remote transmitter's UNLOCK button once to
disarm the system and unlock either the driver's door only, or all of the doors- how the
doors unlock is determined by the installation configuration of the doorlock interface.
Disarming is confirmed by the horn chirping twice and the parking lights flashing twice,
then turning on for 30 seconds to illuminate the way to your vehicle; the UltraOne will
also illuminate the interior lights in the same fashion. During this 30 second period
of illumination, if the ignition switch is turned "on" the lights will immediately turn off.
If the transmitter is not available or inoperative, the system must be disarmed by
use of the Selectable Code Override, which is explained in detail on pages 12-14.
Page - 8