15
6. To program minimum graph percentage,
the display will indicate 0 0 with the right
digit flashing, the bottom most segment
of the bar graph will flash, and the
display will read “PCTFS” (percent full
scale). Press
U
C
,
U
D
➟
to scroll to a
num-ber 0-9. Press
U
u
|
|
➟
to select that
num-ber. The left digit will now begin to
flash. Press
U
C
,
U
D
➟
. to scroll to a
number 0-9.
U
u
|
|
➟
. to select that
number. The 2 digit number entered
represents the percentage of full scale
to be used as the low end of the graph
(0-99%).
7. To program maximum percentage of full
scale the display will indicate 1 0 0 with
the right digit flashing, the upper most
segment of the graph will flash, and
the display will read PCTFS (percent full
scale). Press
U
C
,
U
D
➟
. to scroll to
a number 0-9. Press
U
u
|
|
➟
to select
that number. The left 2 digits will now
begin to flash. Press
U
C
,
U
D
➟
to
scroll to a number 0-10. Press
U
u
|
|
➟
to select that number. The number
entered represents the percentage of full
scale to be used as the high end of the
graph. Note: 100 is the highest and only
possible 3 digit number. If the low num-
ber is equal to or larger than the high
number, the unit will flash “REJCT”
and it will exit back into the “GRAPH”
sub-menu.
Note:
Custom graph function is not available
on vacuum and compound ranges.
Note:
A display message “ULOCK” indicates
that custom units are being used and bar
graph minimum and maximum are set to
the factory defaults
Reset:
Returns the product to the factory default val-
ues.Preserves field calibration. Factory calibra-
tion can be restored in the “RECAL” menu.
1. In menu mode
U
C
,
U
D
➟
until
“RESET” appears on display’s lower
line.
2. Press
U
u
|
|
➟
.
3. Press
U
C
,
U
D
➟
to scroll CNFRM
(confirm) or CANCEL (cancel).
4. Press
U
u
|
|
➟
to select.
Factory defaults pertain to units, timer,
back light, update rate, zero lock.
Display will indicate “DONE” then gauge
will switch to “OFF” condition.
