Omega DP-7600, Руководство пользователя

Страница: 15 / 31

LINE FEED: “LF X[CR]”
The unit can be set to send a line feed character following each transmitted string.
X = 1 line feeds are transmitted.
X = 0 line feeds are not transmitted
ADDRESS ENABLE: “AE XXX[CR]”
The address enable command, in conjunction with the address disable command, can
be used to network multiple DP-7600 units. Once a unit’s address has been enabled it
will respond to all incoming commands until the unit’s address is disabled. When the
address enabled command is executed by a DP-7600 it responds with “HELLO ae
XXX[CR].” Note: a unit address of zero (0) disables the addressing feature and the
address enable command is not required.
ADDRESS DISABLE: “AD XXX[CR]”, or “AD[CR]”
This command disables the unit at the specified address, or when an address in not
attached, all units on the network. When the command is successfully executed the
unit will respond with “BYE ad XXX[CR]”.
READ DISPLAY: “RD[C.R.]”
Requests transmission of the current DP-7600 display reading. The type of reading
returned (i.e. peak, runout, or current input) will depend upon the display reading
mode selected. The unit will format the reading with sign and decimal point as needed.
SET LIMIT: “S# XXXXX[CR]”
Allows remote setting of the DP-7600 limit numbers. The # should be replaced in the
string with the number of the limit to be set (1 through 4).
PEAK AND RUNOUT: “SP[CR]”
When this command is received the peak and runout reading are then reset.
REMOTE TARE: “SZ X[CR]”
The remote tare command allows tare “capture” similar to that performed by the front
panel TARE switch. When a number is attached to the command a new tare value is
captured.
10