3
It is typically recommended that vehicles equipped with turbocharged engines
allow the engine to idle for after driving to cool the turbocharger. When this Installer
Programmable Feature is enabled, the system will automatically keep the engine
running as follows:
• With the engine running, hold the brake pedal and engage the parking brake.
When the brake pedal is released, the system will keep the engine running for the
programmed time (1, 2, or 3 minutes), and then automatically turn it off.
• The system may be locked while the engine is running. Turbo Timer can be
prevented from engaging, or “bypassed” if desired, by turning the engine off before
engaging the parking brake, or if it’s already engaged, step on the brake pedal to
turn the engine off.
This feature will automatically start the engine should the vehicle battery drop
below 11 volts or the interior temperature drop to 15 (or 32) degrees fahrenheit. This
feature is very useful when the vehicle is parked for a long period of time in cold cli-
mates. You must activate these features each time you park and wish to use them.
• Turn the ignition switch “on”, then “off” (engine not running), and within 7 seconds
press the valet switch twice. The system is now in low voltage start mode.
• To activate low temp starting, enter low voltage start mode as described above
but, within 5 seconds of entering low voltage mode, press the valet switch 1 time (15
degrees) or 2 times (32 degrees) within 5 seconds.
NOTE:
When low temp start mode is activated, low voltage start is also activated.
These features will operate once every two hours until the ignition key is turned
“ON”.
LOw BaTTERy/LOw TEmP auTOmaTIC STaRTING
TuRBO TImER FEaTuRE
PIT-STOP FEaTuRE
This feature allows you to leave your engine running for making quick errands. To
use this feature, have the engine running normally from the ignition switch and your
foot off the brake pedal. Press the Valet Switch twice; the parking lights will flash.
Turn the key off and the engine will remain running for the programmed run time.
Valet mode
Valet mode prevents the remote start feature from being activated. It also dis-
ables horn honks when unlocking the doors. Valet Mode should be used when you
do not wish for remote starting to be operated, such as when you have your vehicle
serviced.
To engage Valet mode:
• With the system “unlocked”, press and hold the Valet Switch for 3 seconds; the
Status Light will turn on and stay on to indicate Valet Mode. The lights will flash
twice. Once in Valet Mode, an attempt to remote start will result in no response.
Keep this in mind if remote start stops functioning.
• To turn off Valet Mode, simply press & release the Valet Switch once.
Remote Start Features
using The Valet Switch
