Programming Features Manually
EG-1800
ATV
Page 68
Programming Features
The EG-1800
ATV
has a total of 30 Features which may be programmed via the Valet Switch and the transmitter in a special procedure. The installer has
access to features programming via the FPM-2 Features Programming Module, which can instantly program all features at once. This procedure
is explained in a following section. The Features Programming Mode is accessed through the turning "off" of the ignition switch and properly pressing the
Valet Switch. Once in Features Programming Mode, the Valet Switch is further used to specify which of the 30 Features is to be changed, then the transmitter
is used to program the selected Feature. If two failed attempts are made to enter the Features Programming Mode, two minutes must expire before attempting
again (indicated by a double siren burst or double horn honk). To access the Features Programming Mode, follow this procedure:
Step 1 - Within 5 seconds of turning the ignition "off", momentarily press the Valet Switch 5 times. The security system will respond with sounding the siren
(or horn) for a short period).
Step 2a - The Selectable Override Code must be entered before 15 seconds expires.
Press the Valet Switch the correct number of times - the factory-set default is one press for stage #1 and no press for stage #2. If the system is
configured with the default setting, it will respond by sounding the siren for a short period, then two chirps (or one long then two short horn honks).
In this case proceed to Step 3.
Step 2b - If the system has had the Selectable Override Code custom-programmed, once stage #1 been properly entered (which can be up to nine Valet
Switch presses) the system will acknowledge the entry by sounding the siren (or horn) for a short period, then one chirp (or a short honk). You now have
8.5 seconds to initiate stage #2 of entering the Override Code. Momentarily press the Valet Switch equal to the Override Code number programmed
for stage #2. The system will acknowledge the entry by sounding the siren for a short burst and two chirps (or the horn will sound one long, then two
short honks).
Step 3 - You now have 15 seconds access the desired Feature. This done by pressing the Valet Switch the number of times that are equal to Feature number
listed. For example, to change the Arming Delay to 45 seconds, press the Valet Switch twice as this is the second Feature on the list. The system will
acknowledge the Valet Switch entry by chirping the siren (or honking the horn) a number of times equal to the number of Valet Switch presses.
Step 4 - You have 15 seconds to change the chosen Feature. Press the transmitter's large upper button to turn the Feature ON, or press the small center button
to turn the Feature OFF. Turning the Feature ON is indicated by one siren chirp (or horn honk); turning the Feature OFF is indicated by two siren chirps
(or horn honks). If 15 seconds of no programming activity expires (not pressing either transmitter button or selecting another Feature) will cause the
system to exit the Features Programming Mode, which is indicated by two long siren chirps (or two long horn honks).
EG-1800
ATV
SUPPLEMENT
