Programming Features & Transmitters - EG-1200
ATV
6) Double Pulse Door Unlock: If Feature #6 is "on" the alarm's unlock output will pulse twice to unlock some of the newer doorlocking systems.
7) Steady Siren Or Pulsed Horn Output: Instead of the siren, if the vehicle's horn is preferred, this Feature changes the output from steady to pulsed,
allowing the use of the horn for the alarm's audible responses. If the vehicle does not utilize an existing horn relay, one must be added or this output's 1 Amp
capacity may be exceeded, which will damage the alarm. This Feature is defaulted to Pulsed Horn, but set for Steady Siren at the factory.
8) Horn Confirmation Honk Loud Or Soft: When the previous Feature is set for Pulsed Horn, the arming and disarming confirmation honks may be
adjusted with this Feature. When programming this Feature, pressing the large transmitter button will select a longer output pulse, which will make the
confirmation horn honk louder.
9) Open Door Arming Alert: When this Feature is utilized, if one of the vehicle's doors is open when the system is armed using the transmitter, the siren
will chirp (or the horn will honk) 3 times instead of once upon arming the alarm.
10) Transmitter Activated Anti-Carjacking: This Feature adds Anti-Carjacking protection, and the ignition must be "on" for the Anti-Carjacking to
operate. Press and hold both transmitter buttons for 3 seconds. The siren will start chirping 53 seconds later, and for the next seven seconds pressing the Valet
Switch once will cancel the Anti-Carjacking Feature. At 60 seconds the siren will fully sound, and the parking lights will also flash. At 90 seconds the starter
interrupt output will activate. Once the siren sounds and parking lights flash, Anti-Carjacking cannot be canceled unless the ignition is turned "off", then back
"on"; the Valet Switch must be pressed once within 10 seconds of turning the ignition back "on". This is the only way to cancel or turn off the Anti-Carjacking
Feature - once activated, the transmitter cannot be used to cancel or turn off the Feature.
Up to 4 different transmitters may be programmed into the EG-1200
ATV
system's memory bank. When a new transmitter code is programmed into the system,
all previous codes will be deleted. If a third or fourth transmitter is desired, all of the transmitters must be programmed into system's memory. To program
transmitters to operate the EG-1200
ATV
, follow this procedure:
1)
Turn "on" the ignition switch.
2)
Within 5 seconds of turning "on" the ignition switch, press the Valet Switch 5 times.
Programming Transmitters
EG-1200
ATV
Page 32
