Omega Engineering CN3271 Series, Руководство пользователя

Страница: 12 / 33

9
CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE
CONFIGURATION KEY FUNCTIONS CONFIGURATION KEY FUNCTIONS CONFIGURATION KEY FUNCTIONS CONFIGURATION KEY FUNCTIONS CONFIGURATION KEY FUNCTIONS
RESET In Configuration Mode, it is used only to scroll
back parameters without to memorize a new
parameter value.
Used in Configuration Mode to decrease the
parameter value.
Used in Configuration Mode to increase the
parameter value.
FUNC Used to memorize the new parameter
value and go to the next parameter.
+ Loads the default parameters.
+ FUNC or + FUNC
Increases/decreases values at a higher rate
when modifying parameters.
+ RESET or + RESET
Jumps to the Maximum or Minimum param-
eter value when modifying parameters.
CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE CONFIGURATION PROCEDURE
1) Remove the instrument from its case.
2) Open switch V101 (See illustrations under
“Preliminary Hardware Settings.”)
3) Re-insert the instrument in its case.
4) Switch on power to the instrument.
The upper display will show COnF.
NOTE NOTE
NOTE NOTE NOTE : If "CAL" indication is displayed, press
immediately the
V
pushbutton and return to
the configuration procedure.
5) Press the “ ” key and the lower display will
show the firmware version.
Press the "FUNC" key to start the configuration
procedure with the first parameter (L1).
The following is a complete list of parameters. The
lower display will show the parameter code (L1 to d1)
and the upper display will show the selection code or
numerical value. No timeout is applied in the
configuration mode.
L 1 L 1 L 1 L 1 L 1 = == == Serial Interface Protocol Serial Interface Protocol Serial Interface Protocol Serial Interface Protocol Serial Interface Protocol
(Skipped if option is not available.)
OFF = No serial interface
nbUS = Modbus
jbUS = Jbus
L 2 L 2
L 2 L 2 L 2
= ==
== Serial Link Device Address
Serial Link Device Address
Serial Link Device Address Serial Link Device Address Serial Link Device Address
(Skipped if option is not available or L1 = OFF)
From 1 to 255
NOTE: EIA standard allows no more than 31 device
connected by one RS-485.
L 3 L 3
L 3 L 3
L 3 = ==
== Baud Rate for Serial Link
Baud Rate for Serial Link
Baud Rate for Serial Link Baud Rate for Serial Link
Baud Rate for Serial Link
(Skipped if option is not available or L1 = OFF)
Set value from 600 to 19200 baud.
(19200 baud is shown on display as 1920)
L 4 L 4
L 4 L 4
L 4 = ==
== Byte Format for Serial Link
Byte Format for Serial Link
Byte Format for Serial Link Byte Format for Serial Link
Byte Format for Serial Link
(Skipped if option is not available or L1 = OFF)
8E
= 8 bits + even parity
8O = 8 bits + odd parity
8 = 8 bits without parity
LHL-1-NEUTRO.pmd 19/04/2004, 15.07 9