![background image](http://html1.mh-extra.com/html/omcan/vp-nl-0050-ls/vp-nl-0050-ls_instruction-manual_4169444016.webp)
16
Troubleshooting
The vacuum in the package is
insufficient.
The programmed vacuum value is
too high.
Lower the vacuum value in the
program.
The packaging material is of poor
quality.
Select a better-quality packaging
material.
The product damages the bag.
Program a higher value for Soft-
Air.
The machine gases the package.
Turn off the gassing function.
The seal is leaking.
The package seam is poorly
formed.
Increase the sealing time and/or
reduce the MAP gas pressure.
The package seam is burnt.
Decrease the sealing time.
The opening of the vacuum bag is
contaminated.
Try again and make sure that the
opening of the bag stays clean.
The sealing beam is dirty.
Clean the sealing beam.
The Teflon lining of the sealing
beam is damaged.
Replace the Teflon lining.
The silicon rubber seal in the
counter beam is damaged.
Replace the silicon rubber seal.
There is not enough gas in the
bag.
The bag is too small.
Select a bigger bag.
The programmed gas level is too
low.
Increase the gas level value.
The bag is not correctly positioned
over the gas outlets.
Adjust the bag position.
The machine does not seal.
The bag is not correctly positioned
over the sealing beam.
Adjust the bag position.
The sealing wire is broken.
Replace the sealing wire.
The thermal safety of the power
supply was tripped.
Wait until the safety resets, which
can take half
hour. Decrease
the sealing time.
The electrical contacts of the seal
beam have fouled.
Remove the seal beam and clean
the pins and contacts with sand
paper.
The service symbol appears when
turning on the machine, indicating
the remaining production hours or
cycles.
The service interval counters
have reached their maximum
programmed values.
To reset the service interval
counters after the oil change: Start
the machine and while the display
shows the hours or cycles, press
and hold the “X” button.
Содержание VP-NL-0050-LS
