Omcan VP-NL-0050-LS, Инструкция по эксплуатации

Страница: 15 / 32

15
Maintenance
Troubleshooting
RUBBER SEAL OF VACUUM CHAMBER COVER
To assure that the vacuum chamber is properly sealed, it is important that the rubber seal is in good condition
and is not damaged. Replace the cover seal as follows:
1. Copy the length of the original rubber seal.
2. Pull the original rubber seal from the groove.
3. Clean the groove.
4. Evenly press the rubber seal into the groove; position the ends of the seal tightly against each other to
prevent leakage.
STRUTS, DAMPERS AND SPRINGS
• Machines with transparent covers are equipped with gas struts to open the cover.
• Machines with metal covers are equipped with oil dampers and springs to open the cover.
• Have the struts, dampers and springs checked by your dealer once every 5 years and have them replaced
as necessary.
• Have the gas struts replaced if the lid no longer opens properly.
VACUUM HOSES AND TUBES
• Check the vacuum hoses and tubes for kinks, tears and porosity; replace if necessary.
Fault/Symptom Possible Cause Remedy
Machine does not work. The machine is not plugged in. Plug the machine into the electrical
outlet.
The ground fault safety in the
electrical panel has tripped.
Check the electrical panel.
A fuse in the electrical panel is
faulty.
Check the electrical panel.
A fuse in the machine is faulty. Consult your dealer.
The motor protection of the
machine is switched off.
Consult your dealer.
The vacuum pump does not run at
full speed.
The oil is too thick or
contaminated.
Change the oil.
The pump motor runs on two
phases.
Check the voltage; if correct,
consult your dealer.