Omcan MG-CN-0032-M, Инструкция по эксплуатации

Страница: 7 / 16

7
Installation and Operation
position, and the plug disconnected from the socket.
To assemble the grinder, do the following steps in this order:
1. Insert into the shaft (1) in order: the worm (2), the cutting knife oriented
as shown in the figure (3), and the plate (4).
2. Screw down and tighten the screw (5).
To disassemble, do the above in reverse order.
FUNCTIONING DESCRIPTION
STARTING THE MACHINE
To start the machine, the switch has to be placed on the “I” position.
STOPPING THE MACHINE
To stop the machine, the switch has to be placed on the “O” position.
FUNCTIONING SAFETY
If the machine is under stress, operated for a long period of time or overloaded, stop immediately for the
thermal protection functioning. In this case wait for the unit to cool completely before using again.
OPERATION
The machine operator can begin operation of the machine when:
1. The machine is installed properly.
2. The machine is connected to the electrical supply.
3. The hopper is inserted in the correct position.
4. The grinding group assembly is installed correctly.
5. The worm rotates in the correct direction.
6. Tests the switch.
7. Checks that all safety conditions are being met.
8. Checks that the plug is in the correct socket.
9. Place a collecting tray below the shaft to collect the final product.
10. Start the machine by placing the switch to the “I” position.
11. Manually introduce the chopped meat into the machine neck and use the supplied stomper to push the
meat into the shaft.
12. Once the operation is completed, or when the product no longer comes out of the plate, place the switch to
the “O” position to stop the machine.
It is recommended to only operate the machine when there is product in the unit.
AFTER EACH USE
Once the machine has been operated and is no longer needed for use, please do the following:
1. Before turning off the unit, wait until the food product has finished going through the plate.
2. Turn off the machine by placing the switch to the “O” position.