14
Operation
Maintenance
WARNING!
Before any cleaning and/or maintenance and/or check, switch the machine off (rotational device
positioned “O” = OFF) and then disconnect the power cord from the socket. Cleaning, maintenance or check,
no exceptions, have to performed when the machine is not connected to the power supply.
Before restarting the machine, make sure that no one is touching it. The use and the regular cleaning of the
machine will reduce the need for extraordinary maintenance and repair; the daily cleaning of the machine is
an important factor to promptly detect possible defects or damages. At least once a week, clean the machine
with a soft, dry cloth which does not lose its fabric on the rubbed surfaces. Avoid using petrol, solvents and
any other type of detergent on the non-metallic parts which can be exclusively cleaned with a neutral and
non-foamy water-based detergent. Never use abrasive products, chlorate substances, wire wools, brushes of
any type, scrapers, etc., only use small brushes having sufficiently rigid bristles and cloths which do not lose
fabrics, fibers or fragments.
WARNING!
The machine must never be washed with pressurized water jets.
WARNING!
The machine does not need lubrication or greasing since it is equipped with self- lubricating
bearings.
WARNING!
After a thorough visual check at the beginning of each shift, pay attention to:
•
The cleanness inside the machine while paying special attention to the areas close to the pulleys; if
necessary, clean and sanitize them;
9. To cut other slices having a different thickness, repeat step 5 onward;
10. If the height of the material to cut varies of more than 1 cm when cutting more slices, go back to 1.
