10
Installation
Operation
properly and safely at the work site. By identifying any potential problems (i.e.: equipment location, ventilation,
local fire/electrical codes, installation, operator training and certification) prior to equipment being placed into
service, costly outages and potential damages may be avoided.
CONVERSION KIT INSTRUCTIONS FOR GAS COUNTERTOP HOT PLATE
IMPORTANT SAFETY NOTICE
These conversion instructions are for conversion of the GAS hot plate. The instructions provide in this kit
are for the conversion of Natural Gas to L.P. gas and refer to the conversion of the unit and kit provided.
An authorized licensed technician must be called to perform the complete conversion of the unit. Failure to
properly convert this unit, can result in serious injury, property damage or death and will void warranty.
HOT PLATE CONVERSION KIT INSTRUCTIONS
Warning: Do not attempt gas conversion by yourself. Gas conversion of your unit is to be made by a
certified/licensed technician.
CONVERSION
Instructions are for conversion from Natural Gas to Propane (L.P.) on all models. The conversion should be
done before connecting the unit to the gas supply. Units are shipped from the factory equipped for use on
natural gas. Parts necessary for L.P. (liquid propane) are provided with the unit. Turn off the main gas supply
before doing any maintenance.
1.
Remove the knobs and front panel.
2. Unscrew bolts and pilot valve, then remove manifold.
3. Replace the orifice fittings into the valve.
Note: Unit Number on side of orifice fittings.
4. Replace the front panel and knobs.
5.
Before installing the included convertible regulator, unscrew the octagon cap. You can read (NAT) on the
plastic insert attached to the head of the cap; flip it over and snap back in place.
6. Continue with installation.
Before operating hot plate, it should be checked to see that it is sitting level. Adjust the feet to level the hot
plate. Be sure the catch tray has been properly placed.
The pilot light on the appliance have been set at the factory. Each burner has a pilot light.
1. Make sure all knobs are in the “OFF” position.
2.
The main gas valve should be “CLOSED/OFF” for five (5) minutes prior to lighting pilots to clear any
