14. Position the
nozzle
towards the center of the
tank
(off the material) between
two
slats
.
15. Lower the
Z-axis
to approximately 1 in. (3 cm) above the water surface.
16. Close the lid.
CAUTION
Use care when opening or closing the lid to avoid injury. Keep hand, fingers, or
body part away from the side of the table when closing the lid. Never let the lid
free-fall.
17. Open the
Test
dialog box and run a nozzle test to clear the mixing tube.
18. Remove and replace the
mixing tube
[1] in the proper orientation in the
nozzle
body
(if applicable).
Figure 279
19. Remove the
nozzle body assembly
from the
nozzle inlet body
.
Figure 280
20. Remove the
orifice assembly
[1] and inspect the
chamber bore
[2].
Содержание ProtoMax
Страница 45: ......
