1. Remove the top of the camera. The top is held on with three screws. One is on the right side, just under the
wrist strap lug. The other two are under the film rewind crank. To get to these two screws, it is necessary to
remove the film rewind crank. Open the back of the camera and put a rod or stick between the fingers of the
film rewind shaft (Although a screw driver will work for this, a wooden popsicle stick is the best tool, as this
can’t damage the shaft.). Grasp the film rewind crank and unscrew it. Put the three little screws and the film
rewind parts in the first cup in the ice cube tray. Once the top has been removed, the meter can be seen
directly to the right of the viewfinder.
2. The meter needle is just below the brass plate. With no light shining into the cell, the needle will be fully to
the left, up against the viewfinder.
Содержание TRIP 35
Страница 10: ...10 Remove the screws that hold the photocell in place Put them into the next cup of the ice cube tray ...
Страница 11: ...11 Gently lift up the photocell Grasp the wires and gently pull them thru the camera body ...
Страница 16: ...16 While the aperture assembly is soaking remove the rear lens assembly and clean it ...