EN 30
EN
5. Handling After Shooting
Wash the Case with pure water
1
After use, clean the Case and Lens Port thoroughly with pure water as
soon as possible.
After use in sea water, soak it in pure water for a fixed time (30 minutes
to an hour) to remove any salt.
2
Operate the shutter button and various buttons of the Case in pure
water to clean and remove the salt attached to the shaft.
3
Take it out of the water and rinse with pure water.
Wipe off any waterdrop
Remove any drops of water from the Case and Lens Port. Use air or a soft
cloth not leaving any fibers to thoroughly wipe any waterdrop from the joint
between the front and rear lid, the palm grip, the open/close dial and other
operating parts.
CAUTION:
After coming out of the water, do not detach the Lens Port from the Case or
open the Case. Instead, rinse the entire Case assembly in fresh water.
CAUTION:
• Do not disassemble for cleaning.
• Drying the Case with salt adhered may impair the function. Always wash
off any salt after use.
CAUTION:
• When waterdrops remain between the front and the rear lid, they may spill
to the inside when the Case is opened. Take special care to wipe off all
waterdrops.
• When removing this product from the Case, water droplets left in the region
of the O-ring of the product can be flicked onto the lens or camera body. In
the event that water droplets adhere to the lens or camera, do not panic -
wipe them off immediately with a dry cloth etc.
• When detaching this product, check that it has fully dried before
proceeding.
PPO-EP02_EN.book Page 30 Tuesday, March 24, 2015 10:08 AM
