Olympus PPO-E04, Инструкция по эксплуатации

Страница: 16 / 80

E-4
3 Attaching/Removing the Front Cap
To attach the front cap, fit it into the front end (lens hood) of the PPO-E04 as shown below. The front cap
can be removed by reversing the attaching procedure. Be sure to remove the front cap before shooting.
CAUTION: Make sure that the PPO-E04 is completely dry before attaching or removing the front cap.
4 Adjusting the Lens Hood Position
If the corners of the image in the pickup finder are cut off after the PPO-E04 is attached, adjust the lens
hood position.
Using the clamping screw securing wrench provided with the PPO-E04, loosen the four lens hood clamping
screws on the PPO-E04.
Adjust the hood until the image in the pickup finder is not cut off.
Set the lens hood to the position where the image is not cut off.
Tighten the lens hood clamping screws to clamp the lens hood in that position.
Turn the lens hood to
adjust the position.
Tighten screws to clamp
the lens hood.