Olympus E-M10 Mark IV, Инструкция по эксплуатации

Страница: 165 / 186

Information
8
165 EN
No picture is taken when the shutter button is pressed
The camera has turned off automatically
•
The camera automatically enters sleep mode to reduce the drain on the battery if no
operations are performed for a set period of time.
g
[Sleep] (P. 137)
Press the shutter button halfway to exit the sleep mode.
The camera will turn off automatically if no operations are performed for an additional
4 hours.
The flash is charging
•
On the monitor, the
#
mark blinks when charging is in progress. Wait for the blinking to
stop, then press the shutter button.
Unable to focus
•
The camera cannot focus on subjects that are too close to the camera or that are not
suited to autofocus (the AF confirmation mark will blink in the monitor). Increase the
distance to the subject or focus on a high contrast object at the same distance from the
camera as your main subject, compose the shot, and shoot.
Subjects that are difficult to focus on
It may be difficult to focus with auto focus in the following situations.
Subject with low
contrast Excessively bright
light in center of frame
AF confirmation
mark is blinking.
These subjects
are not focused.
Subjects at different
distances Fast-moving subject Subject not inside
AF area
AF confirmation
mark lights up but
the subject is not
focused.
Noise reduction is activated
•
When shooting night scenes, shutter speeds are slower and noise tends to appear in
images. The camera activates the noise-reduction process after shooting at slow shutter
speeds. During which, shooting is not allowed. You can set [Noise Reduct.] to [Off].
g
[Noise Reduct.] (P. 134)
Image taken appears whitish
This may occur when the picture is taken in backlight or semi-backlight conditions. This is
due to a phenomenon called flare or ghosting. As far as possible, consider a composition
where strong light source is not taken in the picture. Flare may occur even when a light
source is not present in the picture. Use a lens hood to shade the lens from the light
source. If a lens hood does not have effect, use your hand to shade the lens from the light.
g
“Interchangeable lenses” (P. 155)
Unknown bright dot(s) appear on the subject in the picture taken
This may be due to stuck pixel(s) on the image pickup device. Perform [Pixel Mapping].
If the problem persists, repeat pixel mapping a few times.
g
“Pixel Mapping - Checking the
image processing functions” (P. 163)